Roco Rescue

RescueTalk

WE DO RESCUE

OSHA-Required Dockside Rescue

Tuesday, March 06, 2018

Roco now offers marine rescue standby services for the Baton Rouge-New Orleans industrial corridor. As with other Roco services, our personnel are experienced emergency responders trained to provide lifesaving skills when it matters most.

All Roco marine standby personnel are First Responder/ CPR/First Aid trained, and most are EMT’s. Our boats are fully equipped with First Aid kits, AEDs and O2 for prompt emergency care.

For construction work over or near waterways, OSHA 1926.106 requires certain safety precautions – including the timely response of a boat to rescue a fallen worker. In fact, according to one OSHA LOI, the retrieval of an employee from the water is required no more than 3 to 4 minutes from the time they entered the water. And, depending on hazards present, it could be required even sooner.

Section 1926.106(d) states:
At least one lifesaving skiff shall be immediately available at locations where employees are working over or adjacent to water.

The intent of the paragraph is to ensure prompt rescue of employees that fall into the water, regardless of other precautions taken to prevent this from occurring. Thus, OSHA requires that employers supply a skiff to affect a prompt water rescue. As a skiff supplies a backup to potential failures of fall protection devices, the use of fall protection systems is not a substitute for the skiff.

The requirement in 1926.106(d) addresses the hazard of falls that may occur in the event of a failure of the operation of fall protection devices or a lapse in their use. An employer is also required to comply with all other applicable standards including, but not limited to, the requirements that an injured employee be treated by medical personnel or an employee certified in first aid within 3 to 4 minutes from the time the injury occurred. This could mean that first aid treatment would have to begin in the lifesaving skiff or boat.

For more information on this service, please contact Roco at 800-647-7626 or email info@rocorescue.com.

Resources: OSHA 1926.106 as well as Letters of Interpretation (LOI’s) dated 8/23/04; 12/5/03; 12/6/91; and 06/13/90.

NOTE:  In this article, Roco cites OSHA 1926.106 which applies to construction activities while working over or near water. For other industries such as shipyard (Part 1915), marine terminals (Part 1917), or longshoring (Part 1918), please refer to those standards for specific requirements, particularly for PFDs and rescue skiffs. OSHA does not require rescue skiffs for all industry activities. However, keep in mind, OSHA sets minimum standards. And, remember, there’s a safe way and a safer way!

read more 

Roco Training Coming to Lake Charles Area

Monday, February 19, 2018

Roco Industrial Rescue I/II
CERTC Facility in Sulphur, Louisiana
September 24-28, 2018

Designed for those who may respond to industrial emergencies, this 50-hour course will prepare responders for confined space and high angle rescue.

Roco’s Industrial Rescue I/II™ takes a very hands-on approach that provides the skills necessary to meet OSHA guidelines for a competent rescuer. Participants will practice rescue from all six (6) confined space types based on OSHA-defined criteria. These realistic scenarios can be used to document practice requirements as required by OSHA 1910.146. Simulated IDLH atmospheres requiring the use of Supplied Air Respirators (SAR / SCBA) will also be included.

Starting with the basics, students will be taught safe, simple and proven techniques that will allow them to effectively perform confined space rescue from elevated vessels and towers. These skills can also be used for offshore platform environments and fall protection rescue. Classroom lecture will cover applicable OSHA, ANSI and NFPA standards as well as Authorized Entrant, Attendant and Supervisor training.

Click to register for the Sulphur training location today!

read more 

New Pocket Guide from Roco

Monday, February 12, 2018

Newly revised and updated with 82-pages of color drawings and detailed illustrations, Roco's new Pocket Guide features techniques taught in our rescue classes. Made from synthetic paper that is impervious to moisture makes this pocket-sized guide the perfect reference during training or on the scene.

Pocket Guide features: Knots - Rigging - Patient Packaging - Lower/Hauling Systems - Tripod Operations - Low Angle - Pick-off Rescue - High-lines - Confined Spaces and much more.

Reference charts include: Confined Space Types, Suspension Trauma, and Rescue Gear Service Life Chart.

SPECIAL PRICING OF $29.95 THROUGH APRIL 1, 2018 - No Foolin'!

Click here to order your copy today!!

read more 

Another Preventable Confined Space Fatality

Tuesday, January 30, 2018

Comments by Dennis O'Connell, Roco Director of Training & Chief Instructor

The following “OSHA Fatal Facts” is another example of simple safety procedures not being followed or having no procedures in place.

Whether you’re in the refinery, chemical plant, agriculture, shipyards, construction or municipal fields, all of us have an obligation to protect ourselves, our employees and those we work with.

In this case, a fairly harmless looking tank and product resulted in another confined space fatality. As I’ve said many times before, using proper air monitoring techniques is probably the one thing you can enforce that would have the greatest impact on reducing fatalities. This tragic story is another example.

It’s also important to note that while there are different standards for different industry segments, they all attempt to lead us down the same path in using appropriate safety precautions – particularly, in this case, when entering confined spaces. We must remember that these specific standards have all grown from the General Duty Clause, as cited in this article. Basic and to-the-point, the General Duty Clause provides protection from hazards not covered in the more industry specific standards.

I know most of us are used to dealing with more spectacular-looking confined spaces with much more hazardous products; however, this one was just as deadly. It drives home the point…

a confined space is a confined space, no matter how benign it may appear, regardless of whether it’s located at the workplace or the homestead.

If it meets the definition of a confined space, it should be treated as a potential “permit-required confined space” until it is proven that there are no hazards present, or the hazards have been properly addressed.

(Click here to OSHA Fatal Facts)
read more 

Rescue Challenge 2017-Why you should have sent a team!

Tuesday, December 05, 2017

Roco Rescue Challenge 2017 was held at our Confined Space and High Angle Training Facility (RTC) in Baton Rouge, Louisiana on October 11 & 12. This year we had teams representing Petro-Chemical, Paper Mills, Fertilizer Manufacturing and Municipal Rescuers.

The two-day event included performing rescues from all six (6) confined space types based on OSHA-defined criteria. High Angle and Rescue from Fall Protection were also covered. These practical scenarios offer a realistic test of a team’s ability to perform under stress to both IDLH and non-IDLH atmospheres. Teams were required to triage and treat multiple victims as well as select and use a variety of patient care and packaging choices.

This year there were eight (8) rotation stations for the teams to take on. They included some of the following techniques and problem-solving capabilities:

1) An unconscious rope access worker suspended from fall protection in a narrow shaft. The only way to reach the victim was to ascend the victim’s access line.

2) Dealing with a medical emergency in a multi-level confined space that required both external and internal mechanical advantage systems to remove the patient.

3) Real rescue reenactment: Access and extricate victim that fell into and is trapped in a 24-inch shaft.

4) Rescue from an elevated horizontal entry with multiple victims in an IDLH atmosphere.

5) Access and package a victim from a reactor tower requiring both vertical and horizontal internal rescue systems in an IDLH atmosphere.

6) Access a victim with a broken hip via a mid-level 13”x16” horizontal portal accessed via a rope ladder.

7) Individual Performance Evaluation – Team members were tested on their personal rescue skills (Knot tying, Rigging, Packaging, M/A).

8) Multi-faceted Rescue Drill – Tests a team’s ability to adapt and use a variety of rescue techniques and packaging requirements as they move a patient through a gauntlet of rescue stations that traverse throughout the rescue tower.

Rescue Challenge gives teams the unique opportunity to use the equipment and techniques similar to what they would use back at their facilities in an actual rescue, stated Dennis O’Connell, Director of Training for Roco.
He added, “They also get the benefit of comparing their performance and effectiveness to that of other teams performing the same rescue. The teams are exposed to different rescue approaches, which provides a great learning experience in itself.

Challenge also provides an opportunity to be evaluated by multiple rescue professionals from a wide variety of backgrounds. This year more than 10 different evaluators evaluated each team over the two-day event.

The event is set-up so that a team’s capability or experience level really doesn’t matter. Each team is simply responding like they would if that scenario happened at their facility. For example, some teams bring paramedics and others only have basic First Aid/CPR training. It does not matter – it is all about how are you going to respond and handle that emergency.

So why should you have sent a team to Challenge? Besides getting written documentation on your team’s capability to respond to all six confined space types (practice is required annually by OSHA in applicable types of spaces).

It gets your team out of their comfort zone of training in the same locations over and over.
They get to see what other teams do and use. Teams also get the benefit of being critiqued by professional evaluators in order to correct any deficiencies in techniques and equipment. Lastly, the teams are offered positive feedback and suggestions on how to improve from evaluators with a wide variety of experience in the rescue world.

This year's teams included:

Shell Refinery - Convent, LA


Valero Refinery - Wilmington, CA


CF Industries - Donaldsonville, LA


International Paper - Bogalusa, LA


CHS Refinery - McPherson, KS


Don't miss the chance to register your team for Rescue Challenge 2018!
Click here for more information.
read more 

Next
1 2 3 4 5 .. 14

RescueTalk (RocoRescue.com) has been created as a free resource for sharing insightful information, news, views and commentary for our students and others who are interested in technical rope rescue. Therefore, we make no representations as to accuracy, completeness, or suitability of any information and are not liable for any errors, omissions, or delays in this information or any losses, injuries, or damages arising from its display or use. All information is provided on an as-is basis. Users and readers are 100% responsible for their own actions in every situation. Information presented on this website in no way replaces proper training!